Electrical power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Common Description
This electrical power unit is made exclusively to the compact lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit is broadly utilized while in the industry of logistic gadgets like minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed from the solenoid valve using the velocity managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
General Description
This power unit is developed exclusively to the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as the velocity controlled from the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is minimize, the decreasing motion is managed from the manual override perform.
Power UNITS FOR LIFT TABLE 3
Common Description
This electrical power unit is intended solely to the large lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve plus the speed managed by a strain compensated movement control valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This energy unit is built exclusively for your substantial lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and the pace managed through the adjustable needle valve. When the lift rises to a high positoin, but the energy provide is reduce, the lowering movement is controlled from the guide override function.
Special Notes
1. This electrical power unit is of S3 duty cycle, which might only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic elements concerned just before installation of the electrical power unit.
3. Viscosity of the oil shoud be 15~46 cst,which should also be clean and totally free of impurities.N46 hydraulic oil is advisable.
four. Oil transforming is required immediately after the first 100 operation hours,afterwards once just about every 3000 hours.
five. The energy unit shown is built to be mounted vertically.

Tags:

mh coupling

As one of leading mh coupling manufacturers, suppliers and exporters of products, We offer mh coupling and many other products.

Please contact us for details.

Mail:[email protected]

Manufacturer supplier exporter of mh coupling

Recent Posts